Mitsubishi WT-46809 46" Rear Projection Television "break apart end" Questions

...apart and it ended up costing herover a grand as she took out some critical screws that made the main mirror inside the set to drop and break and caused damage to two of the main projection lenes!!! ...

...time the glue comes apart and the tunnel shifts. It starts out like this: |_| and when the glue breaks down it does this: \_\ So the light, instead of passing through the mirror tube, goes

...break something else. First off, I had the conversion circuit changed a few years back. These TVs are famous for them going out, so I knew it wasn't that. I removed the back of the TV and the plastic ...

...apart from the TV and inspected it for damage and cleaned all the mirrors. I inspected the main light bulb and the drive engine for any problems... didn't find anything wrong. Any suggestions??? A ...

...apart replacing bad caps you might as well add the switch or you may end up having to disassemble the whole thing again.) On the FMT board along the top edge near the input connector side of the ...

...apart, there is an aluminum bezel around the screen you have to take that off, and then you will see these goldish tape strips, they are very crapply attached, its hard to solder plastic tape so the ...

break off one side and then your going to have to replace it or rig it somehow. I did have to rig one by putting a small screw it the side that broke. It did work like a champ but I wouldn't recommend

apart to get to the mirror tunnel (a piece about 1.5" long located between the projection bulb housing and lens housing) and, for now at least, the shadow problem has been corrected on my TV. It would

apart untill i know where to start ,,,what can it be ..the tv is 5 years old not very many hours on it pic was excellant ..be ashame to scrape it ..can u help me out .peter The problem is not with the

...apart replacing bad caps you might as well add the switch or you may end up having to disassemble the whole thing again.) On the FMT board along the top edge near the input connector side of the ...