...thanks in advance Hi, I would like to view that short video clip to diagnose possible cause of picture problem and would you please confirm model number of tv that would be written at rear?
picture started bouncing and tv shut down and again blinked 3 times. I then changed remaining resistors and turned tv back on and tv again shut down and now power blinks one time about 4 seconds apart
Question about RCA Televison & Video
...cause tv to bounce slightly an picture will sometimes return for a few min then goes blank again. Also I noticed that when the screen is not going to stay on long it will sometimes seem to have a red ...
Question about Mitsubishi Televison & Video
Picture PC Board. Its a little stand up type board that has a bunch of small capacitors on it and it goes bad just the way you descrbed cause its clipping the sync out of the video. I dont was told it
Question about Mitsubishi Televison & Video
...picture looked great. Moved it 2 blocks in a truck, about 10 degree temp outside. TV was outside 10-15 minutes. Plugged it in, hooked up all components, went to turn on, and nothing but a flashing ...
...cause this? Comment by mastivee, posted on Feb 11, 2008 I did as suggested and the focus doesn't make the situation go away, it makes it a little better but not good. I ran a self check on the tv and ...
Question about RCA Televison & Video
...cause tv to bounce slightly an picture will sometimes return for a few min then goes blank again. Also I noticed that when the screen is not going to stay on long it will sometimes seem to have a red ...
Question about Mitsubishi Televison & Video
...picture would bounce a lot, until about 30 or 40 minutes and then it would be fine. Someone told us to leave the tv on because that was a problem with the projection tv's. So we have been leaving the ...
television model # 9P6040 C104 manufactured in 9/6/2000. Here is what the TV is doing. When I first turn the TV on it looks like I'm watching a TV in a TV with the picture reduced and distorted. After
...around while its on problem is really bad when you first turn the set on any advice or possible causes or solutions would be greatly appreciated Check C2V29 [location on board] a 16 volt 22Mf
230 questions posted
Usually answered in minutes!
1,423 Questions
661 Questions
607 Questions
562 Questions
482 Questions