Mitsubishi WS-55513 55" Rear Projection HDTV "convergence alignment" Questions

Blue convergence will not align red convergence can be aligned, and the blue can be in Convergence 1, but when I go to Convergence 2, I cannot move the blue crosses to align them. You need the ...

...alignment sguares and color lines do not line up. The tv have a problems known as a convergence problems,it dead.Tv have colors lines R,G,B mis alignments,have colors shadow pictures or 3D pictures ...

convergence related problem. Colors mis alignment any R,G,B colors lines.The tv have a problems known as a convergence problems,it dead.The tv convergence board must replaced 2 STK convergence ICS and

...convergence alignment modes but still have an minor issue. this is still a great improvement over what it was when the chips went out. But that last little part is driving me nuts. Is there any ...

...alignment. Seems like ghost images. Tried resetting convergence manually using TV manual by aligning each + symbols. But the green color is totally off and cannot be aligned. Is there any manual ...

...convergence alignment adjustment?Yes,n o,used?The tv colors lines R,G,B mis alignments,have colors shadows pictures or 3D picture look alike?The tv have a convergence problems,it dead.The tv ...

...convergence but the blue alignment did not work. I also attempted to re-set the convergence to factory settings but that knocked all colors out of alignment. The actual picture is not that bad with a ...

...alignment any colors.Tv have a convergence problems,it dead.Tv convergence board require changes 2 STK convergence ICS and some or all it resitors to solved convergence problems.The shop will cost u ...

...Intellisense. U can't alignments this even u have the original remote.Tv have a problems known as convergence problems,it dead.Colors lines R,G,B mis alignments,have colors shadows pictures or 3D ...

Red horizonal convergence tilts instead of adjusting evenly. While attempting to adjust the convergence on my Hitachi 53FDX01B the red convergence will align vertically but when I attempt to align it ...