...projector lens and that could be the source of the problem,dust being blown into the compartment with the mirrors. Cleaned the mirrors really well and used double stick tape to reattach the foam to ...
...with a microfiber cloth. no water, no glass cleaners. i also used a very fine new small paint brush and dusted the projector lens which also had a dust film. brightness, contrast and clarity
Question about Mitsubishi WD Televison & Video
...projector lens which also had a dust film. brightness, contrast and clarity returned! I have been having the same issue. Today I tried to tackle the issue and see if I could fix it myself by cleaning ...
Question about Mitsubishi WD Televison & Video
...projector lens. This gives you access to the RGB LED'sAt this point is where I start going over everything with the compressed air till I dont see any more dust flying around. This is also why I ...
...and lift off, only about 8 pounds, now clean the little mirror in front of the projector, and clean the dust off the projector lence, that will solve it, iv had to do this on about 50 of thease ...
...dust on the projector or projector light. it could also be one of the camber mirrors in side the projector has come loose or discolored. if the menu comes up ok then it is the avi board control chip ...
...dust out my tv so can you help with. First, my disclaimer: I have a much older projector, but the way they are constructed hasn't changed a lot to my knowledge. An excess of dust can shorten the life ...
...dust into a worse location that previous. Make sure duster can does not spray fluids into projector, or you have a bigger mess. dlp projectors have sealed optics. don not use anything on the lenses ...
...dust or something in front of the projector I did not see anything obivous. I did see that one side of the projector or what I think is the projector for all I know it could be the light engine it's ...
...dust and so is the mirror. Hi my name is Roety, I can help you with your issue , Leave the top rear half bolted on. Remove the rear edge screws to remove the front half, then remove the front lower ...
140 questions posted
Usually answered in minutes!
1,423 Questions
661 Questions
252 Questions
240 Questions
221 Questions