Question about Mitsubishi Televison & Video
resistors near them.. pull one side of the resistor out of the board so you can check it out of circuit. they will usually have the value in Ohms, printed directly on the resistor, but you may have to
Question about Mitsubishi Televison & Video
resistors near them.. pull one side of the resistor out of the board so you can check it out of circuit. they will usually have the value in Ohms, printed directly on the resistor, but you may have to
resistors near them.. pull one side of the resistor out of the board so you can check it out of circuit. they will usually have the value in Ohms, printed directly on the resistor, but you may have to
...your convergence cartridges and check your resistor specially the fusible ones and all low values.. a small change in value can prevent any automatic convergence circuits from operating ...
...convergence IC?s replaced. I am wondering if it is advisable to use STK392-150?s instead of the factory STK392-110?s. I see in the spec sheet that they are rated for higher wattage, but wondering if ...
Question about Mitsubishi Televison & Video
...resistors that are part of the convergence circuit that will be open and need to be replaced. Most likely these will appear charred in the center. If you have an Ohm Meter or a DVM, check all the ...
...value.. 2.Resistors -change value resistors and open resistance can cause the same problem this resistors usually near the regulator transistor.They appears as burned and overheated replace it with ...
...resistors that are part of the convergence circuit that will be open and need to be replaced. Most likely these will appear charred in the center. If you have an Ohm Meter or a DVM, check all the ...
Question about Mitsubishi Televison & Video
...value 1-watt flameproof resistors in the convergence yoke circuits. They typically range from 1 to 3 ohms. An open resistor will cause the respective color to be non-responsive. Also chack that you ...
...resistors in the convergence circuit because I have no clue which resistors go bad . On my 60" zenith I fixed it with an r 3243 resistor on the smps module . could a person in the know about which ...
1,606 questions posted
Usually answered in minutes!
661 Questions
252 Questions
240 Questions
221 Questions
188 Questions