Mitsubishi WD-52525 52" Rear Projection HDTV "tv 57731 turns" Questions

...57731 The lamp light blinked orange. i replaced the lamp turned the tv on and the timer blinks green for one minute and then the lamp light blinks orange again. It won't turn on. Can you suggest ...

...57731 DLP TV won't turn on. On the front panel there is a blinking yellow light. What does this mean? Based on the service manual: Blinking yellow= Lamp cover is open. It could be something else! ...

...57731 LED Timer Light Green LED Timer Blinks continuously; No picture, no sound, no electrical activity taking place in back of TV set. TV set has been isolated from cable service and have attempted ...

57731. A message flashes at the bottom of the screen saying TV will power down check air flow. TV then goes off, lamp light flashes for a few seconds, i turn the TV back on and this repeats for 3 or 4

...57731 1080p My tv giving a signal that the air flow is block but It is not close to the wall it has plenty of room to breath it wasnt so bad but now it does it all the time. see if there is dust ...

57731 Will turn on, I get sound but no picture. The lamp light is not on at all, not green, not amber. The timer light blinks for a short period (I have it set to slow power up so it always does this)

57731 DLP TV. The TV started cutting off and the red lamp LED would come on. The first time it went out, I started by vacuuming all the vents and filter areas which didn't work) I then purchased a new

check airflow sensor turn tv off Your TV needs the modified temp sensor installed by Mits authorized service center. It's covered under extended warranty for 3 years after date of purchase. Repair ...

...57731 wont power up Hi I tried turning on my tv with the remote and nothing happened.I un plugged it and replugged it and the green timer light flickered for about 30 sec and stopped but the tv never ...

tv was turning itself off now it wont come on at all Replace lamp. Clean (vacuum thoroughly) cooling fans. Make sure they are vacuumed and turn easily. Lubricate them with a tiny drop of Z-Max on each