...lamp door switch, if the door that covers the lamp is not closed correctly or the switch is not in the right position the set will give your symptom, the only other reason would be a bad ballast and ...
...switch for the cover panel of the lamp so I could watch what's happening when I turn on the tv and I could see the lamp turn on but after 5 seconds it turns off. I do not beleive the new lamp is ...
Lamp cover will engage to micro-switch and make it in closed position. If the lamp cover is not properly seat in, this switch will be in open position and will make that kind of symptoms. Double check
...switch. If lamp stops working, while there is no "amber" light, then TV shuts off, red blinks, lamp is bad. I just had to replace lamp twice, due to defective batch of lamps with housing. 3rd time I ...
Question about Mitsubishi WD Televison & Video
...switch behind the lamp itself, as well as behind the cover).Providing the micro switches are engaged properly, the TV set should power up normally.If not, there must be another underlying issue ...
...Lamp enable line at J14 pin 6 does not switch to 5 volts after turn on, 12 and 5 volt supplies are good. Suspect the Light Engine part # 939P977020 6. Lamp enable line at connector J14 pin 6 on the ...
...Lamp enable line at J14 pin 6 does not switch to 5 volts after turn on, 12 and 5 volt supplies are good. Suspect the Light Engine part # 939P977010 6. Lamp enable line at connector J14 pin 6 on the ...
...Lamp enable line at J14 pin 6 does not switch to 5 volts after turn on, 12 and 5 volt supplies are good. Suspect the Light Engine part # 939P977010 6. Lamp enable line at connector J14 pin 6 on the ...
Question about Mitsubishi WD Televison & Video
...know if it is the lamp we need to replace?? Thats indicating that the lamp door cover isnt installed properly or the lamp door cover switch is malfunctioning. Check the door and its switch carefully
Question about Mitsubishi WD Televison & Video
lamp light comes on and unit shuts off. Check the lamp door to make sure it is seated properly I believe the red light indicates door switch problem. It shows you lamp error data in the service manual
1,606 questions posted
Usually answered in minutes!
661 Questions
252 Questions
240 Questions
221 Questions
188 Questions