Mitsubishi WD-52525 52" Rear Projection HDTV "sensor cost tv" Questions

...sensor and for a certain amount of time they would fix it. Of course we were beyond that time, but hubby was able to do something where we split the cost. No problem since and haven't vacuumed it ...

...sensor. I just had mine fixed at no cost by an authorized service provider. this is commopn problem. i have seen were the thermal sensor needs replaced I just had this problem happen to me, tonight. ...

...TV turn on. Other than that, could be a bad lamp or bad ballast. Always buy OEM lamps, or better-than-oem equivalents! Philips lighting is the best lamp manufacturer out there for these TVs. They ...

...air flow sensor is defective. The message you are seeing is a result of the air flow not being detected or not sufficient. In any case, this is a covered problem and should cost you nothing to fix. ...

...tv will automatically run a check from time to time to check how much power the lamp is drawing. The sensor will reset itself every time the set is turned off and the cycle repeats itself. I am 1000% ...

...cost me a total of $30 to fix my TV. The authorized Mits repair man i had out to look at my TV before i tried to fix myself said that i need a new ballast and/or light engine and quoted me anywhere ...

sensor or convertion board are too costly for the part.Buy a new TV. solutiondoct mine was the 904 and 905 pico fuses in the power board. $4.00 is what the fuses cost me. I put them in myself and have

sensor. That fixed the problem. If you are tech savy than it shouldn't cost more than $15 to fix your tv if not it'll be a lot more. Other suggestion is to get a vacuum and clean out the junk from the

...sensor? or how much would it cost to get it repaired? Thank You Mats Electronics will have everyhting you need to fix both problems Remotes and STK ICs in Convergence circuit STK392-110 use 150s also ...

...sensor with black electrical tape. Then it is safe to work on the tv when it's open and on. Well safe for those who know what they are doing. yes had same problem must have convergence chip replaced ...