...Lamp Temperature 39 Excess DMD Temperature 41 Short Detected 44 DVI Cable (between Chassis and Engine) disconnected If the code is lets say 36 the LED will flash 3 times then pause then 6
Question about Mitsubishi WD Televison & Video
...Code is ?32?, the LED will flash three times, pause, and then flash two times. ? The Error Code is repeated a total of 5 times. 4. Error Codes The Error Code designations are listed below: Error Code ...
...led blinking. no picture no sound >>The first thing to do is a system reset using the recessed button on the front panel. >>If that does not work, unplug the set and let it sit overnight SYSTEM RESET ...
...led VU meter,, thanks jay Here's something that might also be useful. After you turn on the set, and get the regular red blinky lights, hold down the Device and Menu buttons together for about 5 ...
Question about Mitsubishi WD Televison & Video
...code flashed out through the LED's.. the codes are as follows: 12 No error detected 22 Recovery from momentary Reset 32 Lamp Cover open 33 Air Filter Cover open 34 Lamp abnormality 35 Chassis Fan ...
Question about Mitsubishi WD Televison & Video
LED probably means the 2 - 3300UF caps on the power supply board are bad. You can tell if they are bad by the fact that their tops are puffed up and they may or may not be leaking brown fluid. Compare
Code Mode. The ?Power LED Light? blinks/flashes (1/2 sec delay) and then flashes again denoting a two digit Error Code indicating no problem or an error has occured since the last Initalization. i.e.
...LED flashes 3 times. Is this a possible fuse problem or power transformer. Thanks Here's something that might also be useful. After you turn on the set, and get the regular red blinky lights, hold ...
Question about Mitsubishi Televison & Video
...led The set has a self check--try this(posted by another expert here): "Here's something that might also be useful. After you turn on the set, and get the regular red blinky lights, hold down the ...
...33 = Air filter cover is open. 34 = Lamp abnormality 36 = Light Engine (DMD or Lamp Fan stopped) 37 = Exhaust or Lamp Ballast Fan stopped 38 = Lamp Temperature High 39 = DMD Temperature High 41 = ...
1,606 questions posted
Usually answered in minutes!
661 Questions
252 Questions
240 Questions
221 Questions
188 Questions