Ricoh FT3713 Copier "repair printer turn main power" Questions

...turn on even tho plugged in Try a different power cord or test the power cord on a different piece of equipment. If it still does not work then the printer has a power supply problem and needs to be ...

...repair.1- Turn off power and unplug from power source. 2- Open right side of printer (looking at the front). 3- Disconnect,by pulling gently, both white flat ribbon cables off the main circuit board. ...

...turn on the machine it comes up with a C9401 error code. ?It did this before the cable repair as well? We are aware that this could be associated with the exposure lamp, but since the exposure lamp ...

or the Main Board has failed I'm afraid. This is a job for a Technician - but make sure you know the full cost of repair before you commit yourself - it may well be more than the cost of a new printer

...switch off/on.You must be performed to clear the service call conditions: 1.After repair the machine turn on the main switch. 2.Enter in the SP mode and press 97. 3.Turn the main switch off amd

turn on.Any help would be very much apreciated. I assume you checked the power cord. If you have changed the internal power supply (the black box in the left real corner), then all that is left is the

...turn on when I push the power button.... but when I click off then on on the power saver cord it comes on and says self test then it goes off again ...then it blinks one more time and off it goes for ...

...repair my faithful printer? With hopes, David Wake. check if the ribbon that goes from the control panel to the main board is attach correctly, if is ok , am afraid you might have to change the main ...

...machine turn on the main switch.-enter SP mode 9-turn the power switch off and on.E53 = temperature detected by the fuser thermistor higher.Causes:thermistor short,triac short.fusing harness ...

...printer is often considered beyond repair, and in any case it must be tested by a technician to find out the problem.Repair involves testing volts out from power unit and testing components on main ...