Ricoh FT3713 Copier "printer paper lines roller" Questions

...Printer will not feed the paper depends on following possibility. Paper Type: If surface of the paper is too smooth, pick-up roller will not feed the paper. In such case, try with different type of ...

...paper through the mechanism. If the printer is relatively new, the rubber rollers should be in good condition. As the printer ages, these get less rubbery and more slippery, and wear out, leading to ...

one line. Usually when a printer can't feed paper evenly anymore, it's worn out. As long as you are using fresh paper and not over or under loading the paper tray, the rollers should feed the paper ok

...paper in a temperature controlled area. 4. The transfer roller could be going bad. This is the spongy feeding roller in your printer which is right under the cartridge head when you put it in your ...

...printer can feed the paper. The open position is for installing paper or clearing paper jams. Also if I recall, the lever is on the right side near the roller on the end. When you move the lever, and ...

...paper. It will get bigger once it span of time. Or if you are refilling the toner of the catridge, the waste compartment is full and requires to remove the waste tones inside the cartridge. Or the ...

...end. Make sure the clamps that keep the paper lined up are lined up properly as well. One last resort is to do a power down and power up. If none of these things work, then you may need a new

...paper feed roller is not pulling the paper down evenly. It appears that the bar on the left paper feed wheel is out of line. how can i access the rollers to rectify this This article in the Lexmark ...

...paper but still the same. Your printer's rollers sound like they are worn along the paper path. I suggest you taking your printer in to have a maintenance cleaning or have the rollers replaced. This ...

...paper are not meshing or engageing the the gears beneath them, Is there a drive belt or a possible broken gear that i can't see causing the problem? thanks Frank Hi, Try cleaning the rollers in X4270 ...