tray by gently lifting on it and check to see if there is any paper jamming it from lifting. If there isn't any, the lift motor may need to be replaced. The end fence of trays broken or out of psotion
tray doesn't lift than there may be a problem with the lifting motor. remove the right cover assembly and near the center bottom is the motor assembly. insert the tray and check to see if the motor is
tray lift motor error. It should be looked at by a technician to see if the sensor or motor needs to be replaced. If you want to use the machine for now and bypass the error. Turn the power off on the
...has a bad lift motor. Remove all the tray 2 paper and look for any paper scraps in the tray. Reinsert the paper and listen for the motor and watch the tab. If it works, great, if not call a
Question about Toshiba Office Equipment & Supplies
...there.. if you put the trays back in on at a time you should find the one causing the problem.. my money is on the lift motor as this lifts the tray up to the paper sensor to show paper in
Question about Ricoh Office Equipment & Supplies
...3 and it working fine, then exchange with tray 1, if working that's mean the senser actuactor on the tray 1 is broken replace it, otherwise that's lifting motor defect, replace lifting
Question about Toshiba Office Equipment & Supplies
...thanks Might the lift motor is not working, or try to hold the tray pressing in and wait, you can hear the lift motor sounds and stops if not your lift motor assembly is failed it can be
Question about Xerox Office Equipment & Supplies
...Tray 1 lift failure. You probably can hear the motor lift 127K38171 when you re-insert the tray, so maybe the lift motor is bad or maybe a sensor 930W00113 is falsely accusing our motor. Whit Item, ...
error can occur. Pull the tray out and on the right hand side you will see a geared piece of plastic, rotate it to see if the tray lifts when you do. If not the tray might be the problem not the motor
...with the tray. Clear the motor error code with SIM 15 in the service area of the machine (from copy mode, # * C * to access) If the code comes back your lift motor is worn out and needs to be ...
108 questions posted
Usually answered in minutes!
629 Questions
382 Questions
267 Questions
215 Questions
218 Questions