...ribbon spindle and slide it on the front ribbon spindle. You then load the new ribbon on the back spindle and attach the ribbon end to the empty plastic ribbon core on the front spindle. You CAN ...
ribbon but the spindle that receives the ribbon seems to be functioning properly. Right now, the inner part of the spindle will turn but the outer part of the spindle will remain stationary. Therefore
Question about Zebra Office Equipment & Supplies
...ribbon attached to the take-up spindle, does the take-up spindle still spin? If not, check the belt/pulley inside rear cover of printer. 3. Take-up spindle (and feed spindle, for that matter) have a ...
Question about Datacard Office Equipment & Supplies
...spindle of the ribbon cartridge. Push until the spool clicks onto the spindle. ? Put the empty take-up spool on the spindle with the solid black gear. Push until the spool clicks onto the spindle. 6: ...
Question about Zebra Office Equipment & Supplies
...ribbon tense Your supply spindle is "too tight". Procure a "Washer Felt w/lube kit" (Zebra part number 01688-140) and rework the supply spindle. Use only the supplied silicone oil to service the felt ...
Question about Zebra Office Equipment & Supplies
...ribbon take-up pressure needs to be adjusted. Supply Spindle: a pair of set screws near the outermost point on the spindle locks the adjustment in place. Loosen the set screws, then move the center ...
Question about Evolis Pebble Office Equipment & Supplies
...contrast set too high. If it breaks as it feeds under the printhead (while printing) your contrast may be set too high. You also could have a ribbon spindle issue. Are both ribbon spindles
ribbon spindle is not performed or not correctly detected. This can be due to various factors. - The ribbon roll is not correctly fitted to the spindle. - The sensors detecting the rotation are out of
...ribbon take-up spindle release knob counterclockwise, squeeze the ribbon against the ribbon take-up spindle tension blades. When the tension blades collapse into the ribbon take-up spindle, hold the ...
...that I'm not aware of. You may have installed ribbon incorrectly. Align the gears of ribbon spindle with gears on printer and second important thing is that ribbon should come from up not from
29 questions posted
Usually answered in minutes!
29 Questions
1 Questions