...fix it you have to open the amp and redo the solderings (there are about 50 or 60 of them). There is a Youtube video that shows how to do it. I have fixed this on my DSP-A1. I also have the problem ...
...50- 100 to get it fixed. and then you might run ito other problems after that........ 120 is not bad for a new one sorry for the bad news good luck sounds like an open circuit on the output side of ...
fix though. It will probably need both a display controller board and the display itself. I think that the display is ok, but it has about 50-60 solder joints to the board that would have to be undone
...fix themselves when you reach 75%. Try shaking the volume knob while in the 30-50% range and/or try (with the power off) rotating the volume knob numerous times from 0% to 100%. If when you plug it ...
Question about Denon Audio Players & Recorders
...fix both fairly easily. The issue is related to the voltage regulators on the power supply board on the 1708 and the main board on the 687. In my case, I had failures of the -15 volt regulator ...
...50 volts the amp ic is bad for sure and will need to be replaced. Most times when they go bad all yo need to replace is the amp ic. sometimes the 5 watt resistor will open up as well. you can check ...
...50, lol !) . I would like to try and diagnose and fix the problem myself. To start check balance settings, and cut power from battery for ten minutes to reset the system. Depending on the model, you ...
...fix. see i tell you in detail.. now i am using a converter with output rating as 110/120 v ac and current as 50watts.. where the power rating written behind the amp is 110v ac 60htz.. first kindly ...
53 questions posted
Usually answered in minutes!
192 Questions
173 Questions
140 Questions
146 Questions
92 Questions