Yamaha HTR-5850 Receiver "amplifier turn" Questions

Denon AVR-4802R automatically shuts off in multi-zone mode When operating in multi-zone mode (after amplifier was off for couple of hours), the amplifiers shuts off automatically. At this point only ...

...amplifier not to turn on. Make use of voltmeters to check if your amplifier is getting the right amount of power for it to work. Amplifiers need 110 volts or less to function if the power coming in ...

...no sound for 2-5 minutes after turning it on when it is cold. After warm up it is fine. i have an amplifier ONKIO too and my generation is older than yours but i'm the same probleme and it's normal ...

...and if not then buy another amplifier with Phono function coz you need a ground wire [that comes out from the turn table] also to be attached to the amplifier and then only you can get a proper

amplifier. When I turn the system on it works but the amplifier turns off after about 10 minutes. When the system cools, I can turn the unit on again, and the system works. I noted that the fan in the

...turn the unit off, to lesson further damage to the amplifier or speaker system. There can be other causes of why the unit's DC Protection relay is not engaging, but 90% of the issues, are related ...

...the receiver and it is clipping the audio and making it sound bad. Last 20 years, the normal amplifiers or receivers don't have pre amplifiers for vinyl record players. And before that only

when playing the DVD when you turn up the volume the amplifier turns off. Amplifier and an over load issue and is shutting down to protect the circuits. Needs to be checked out by tech.

...indicating the power wire is fine. Would pl If you can desolder the audio amplifier IC to check the device turn on,If the device turn on with the audio amplifier IC desoldered you need to change

amplifier turn on againyou the amplifier after turn on after 5 seconds go to Video 1 and you can't change to other input, the amplifier don't do nothing if you turn off , the amplifier turn on