...speakers than two 8 ohm units so connected to an output jack of the amp rated at 4 ohms. You will LIKELY want to connect the monitors to one of the jacks and the mains to the other so you can have ...
...Peavey mixer. You can run faux stereo by using the Main monitor Out as 1/2 the pair and the Main Out as the other 1/2 to both channels of the crossover but you won't be getting a true stereo pan
...Main/Monitor) you are best to have a 4 ohm total load for each channel of amplification. Ex.--Mains only, one 4ohm speaker per channel will give you 600W per side. Or two 8ohm speakers per channel in ...
...channels are about 400 Watts and 600 peak. Frankly myself I prefer to use both MAIN channels to the main speakers and use an external amp for the monitors OR use powered monitors for monitor
...monitor speakers with no less than 4 ohms combine, you can use the built in Mon mode without any additional cables. You will set the mono/mon positon (center) and use the mo1 slider to control ...
...monitor sends. Send main 1 out to your Crown. Jump Mon send to PWR am insert. According to the specs on your Behringer you are getting 600 watts per channel. That is all you would get from your power ...
MAIN fader will be around 50 to 80% depending on how big a room you are in. I assume the Peaveys are on separate channels IF they are 4 ohm speakers. The A and B outputs have a MINIMUM load of 4 ohms.
107 questions posted
Usually answered in minutes!
192 Questions
108 Questions
69 Questions
32 Questions
