...carb, replaced both fuel lines and filled with fresh gas. What can I do to get the engine to run beyond full choke? This is a tell tale sign of a lean fuel mixture. By choking the unit you are ...
...carb body in a vise and cut the screw slots thru the aluminum guard. Be very gentle, the screws are soft steel. If I had to do it again, that's what I'd do. Get it running and adjust the "L" at idle ...
carb unless you are a repair tech, so i just took a Dremmel tool with the circular cut-off wheel to the head of the specialty screws and made them into "flat-head" screws so i could adjust them with a
carb unless you are a repair tech, so i just took a Dremmel tool with the circular cut-off wheel to the head of the specialty screws and made them into "flat-head" screws so i could adjust them with a
run" selector (aka choke) area on the carburetor. They are jets for your carb that control fuel/air mixture. If the world was a sensible place they would have slots for a screw driver - but it isn'
Question about Toro Garden
...carb a little richer and make sure your ratio of oil to gas is right. the motor is running to hot and sounds like it is not getting enough lubrication. This is called lean condition and will ...
...run position. Normally I have to use it when in the 1/2 choke position. It has caps on the carb mixture adustments, otherwise I would be adjusting the high speed mixture richer. What can I do? If you ...
...carb to a richer setting after warmup, then readjust when cold. Help! What are you trying to do. There is no actual cold setting that a carb would be set to. Cold running is either by choke or bypass ...
...carb, on controlled by lever and another by throttle.basically now you haave half choke. you release trigger, goes back to 7/8 choke to keep at idle but not running. your ready to go. on the cs30 its ...
97 questions posted
Usually answered in minutes!
778 Questions
175 Questions
129 Questions
92 Questions
66 Questions