Waterway Executive 48 Spa Pump 2hp 1spd 2" 34108301 () "pool motor wet" Questions

...pool motor aol 1-1/2 hp Dismantle to Components It depends which pump you have, on hayward super II you shut off the breaker, remove the rear motor cover, disconnect the electrical wires, then remove ...

...AT THE MOTOR.. SOUNDS LIKE YOU MIGHT HAVE LOSE WIRES AT THE MOTOR, TIMER, BREAKER OR A SWITCH IF YOU HAVE ONE I'M YOUR LOCAL POOL PUMP REPAIR GUY IN LONGWOOD FLORIDA. WHERE THE POOL IS ALWAYS ...

removed four bolts,can not get motor off depending on the pump you have, you'll need to remove the seal plate from the wet end and remove the impeller before you can remove the motor.

pool spa motor 1081/1563. Emerson is not the name of the pump, that's the brand of the motor attached to the wet end, and the two together make a pump. 1081/1563 only means that it meets the standards

...pool/spa Pumps! Just motors. Then pump manufacturers utilize Emerson as a 3rd party vendor to supply them with a motor for their Wet End. Then when their Wet End is installed onto a motor, like ...

...motor from the wet end of the pump remove the cover on the impeller then remove the impeller screw it it normally backwards thread then spin off the impeller this has a regular thread split the motor ...

pool motor leak seal replacement If you are asking how to replace shaft seal? open & dismantle pump from motor. Some will have thru bolt motors all the way thru the motor, heads of bolts are (4 ...

...motor to wet end. Pull motor back and out of wet end. Diffuser should just fall off. Not held by anything, there are just some locating tabs. Next, unscrew impeller. Some impellers may have a screw ...

...filter turns off after about 30 minutes, it seems to get hot and then will not turn back on for many hours. the pool is new. The thermal overload switch on the motor is bad. Take back for

...motor into the wet end, or pump. Use a 1/4" nut driver and loosen the bolts until they are free of the wet end, then you can rotate the wet end so the discharge is face to the side. Tighten the bolts ...