Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer "pulling plug wire engine running" Questions

...wire to plug, touch plug to engine and pull rope to observe spark, then short the tab on the magnito to ground, should be no spark. If you still have spark, coil is defective however good enough to ...

...pulling plug wire. This engine is on an older Craftsman power washer. Hi When lever is turned to stop position look under the levers" support and see if there is established a conection with the wire ...

...wire back on plug Touch threads of spark plug to metal part of engine > pull cord and look for sparking between spark plug and engine If you do NOT have any sparking, then coil is bad If you HAVE ...

...plug the ignition wire back and remove the air cleaner see if it will start then .witch the choke on . If it still won't start try pouring a small amount of fuel derictly into the carbuator if it ...

...plug gap should be preset, But I'm glad you mentioned the compression, it should be 100 lbs.. , 70 lbs min, or it won't start. You might have a valve burned out from the choke being on. Most engines ...

...engine for spark at spark plug.No spark.What should I check? John Sounds like an ignition issue. Pull the Distributor Cap and check for water vapor and/or electrolysis on rotor and cap terminals. ...

plug wire off the plug or try to touch the end of the plug and the engine at the same time. If the switch is in the gas lever there may be an adjustment on or in it that shorts the plug out. Make sure

plug wire pushed all the way onto the spark plug? Now the nitty gritty of starting that bad boy and making you happy again!!!! 7) Take off air filter. Spray WD-40 directly into carburetor. Yes, we use

...and holding plug against the engine frame and pulling starter rope if spark is present replace the spark plug and try to restart the engine. If these steps don't work I would replace the

...plug wire pushed all the way onto the spark plug? Now the nitty gritty: we're gonna start that thing right now 7) Take off air filter. Spray WD-40 directly into carburetor. Yes, we use WD-40 every ...