Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer "engine internals" Questions

...repaired or is it cheaper to get a new pressure washer Hi, with lack of oil, I would say that the engine is ruined internally. This of course depends on what is broken internally. One can purchase ...

cant keep engine running in run mode only with choke carburetor is probably dirty internal, disassemble and clean.link below should be helpful. How To Service Honda Carburetor Most Honda Engines press

...for a Honda GC160 Power Washer? Honda 2500 PSI x 2.3 GPM. The type of oil recommended for that engine is SAE 10W-30 and the capacity is 0.61 quarts. This and more can be referenced at the

why does my brigga and stratton 3000 psi pressure washer engine cut off when I release the trigger? It sounds like your unloader valve is failing, you would need to either lube up the internal valve ...

...etc. Make sure you have good gas (if the gas is over 6 months old it may be "sour" and causes the engine to backfire- backfire is a very bad thing on these small engines). The bang is what concerns ...

...2400psi Milky-looking oil is a sign of water mixed-in with the oil. This is often a sign of severe engine damage (cracked block, cracked head) in a water-cooled engine. (i.e., one having internal ...

idle problem engine began surging at idle.It was stopped and checked over then restarted when it immediately went to full revs. Governor adjustment seems to be ok. There is an arm that runs from the ...

KOHLER HYDRO 13 When pressure washer engine is KOHLER HYDRO 13 3500 PSI When pressure washer engine is running and hooked to water supply, there is no water spray with trigger is depressed first sheck

...ones) should have pump saver antifreeze and lubricate cycled into them upon storage. Fuel for the engine should have fuel stabilizer put in the fuel and cycled through the carburetor and fuel

Why is pressure not building up to cut off? Electric pressure washer engine works fine. Replaced piston seals. Can this be a pressure regulator issue or an internal check valve issue The pressure ...