Poulan 18" Wild Thing Chainsaw "idle screws" Questions

Ad

Question about Husqvarna Garden

1 Answer

...screws, 1) the idle speed screw, 2) is the idle speed mixture screw. The idle speed screw is located on the carburetor, nar the throttle arm where your throttle cable is connected. There is a screw ...

Ad

...idle to half throttle ( they are fuel screws not air screws ) the H screw will adjust from half throttle to maximum revs, start with a base setting of between one turn and one and a half turns out, ...

Ad

idle screws.the high and low are side by side.the bigger screw below them is the idle screw.first take the high and low screws and run them in clock ways.don't tighten them,just snug.now back them out

idle..Will run at high rpm's, but when you let off of the trigger it just dies, then I have to choke it to get it to start back. try adjusting the Hand L SCREWS ,with a small screwdriver---screw the L

...screws right in[gently]then out 2.5 turns.start it up,screw the idle screw up till it will idle,then adjust low speed mixture screw in or out so you get the highest idle.keep lowering the idle so as ...

...may have tamper proof covers on for emissions regs. Remove the top cover and you should see the screws on the side of the carb. H&L are side by side, idle is on the linkage to throttle

Question about Husqvarna Garden

1 Answer

...idle,I see the low and high screws First there is an throttle idle screw that adjust the amount of throttle at idle try turning it ccw until it idles down. If this adj is at its lowest level then ...

...idle screw. It should just open a little bit the carburator butterfly. Second full close both ''L'' and ''H'' screws (turn clockwise). After open both ''L'' and ''H'' screws 1/2 to 3/4 turn ...

idle. Is all I have to do is screw in the "T" adjustment screw in all the way and back out one turn and start from their? I didn't adjust the other L&H screws. Thanks, Patrick screw it in and then

chainsaw blade turns constantly, even when idling. If the chain turns on the bar when the saw is at idle, then the idling speed is still too fast. If you turn the idle screw down until the chain stops

Not finding what you are looking for?
Poulan 18" Wild Thing Chainsaw Logo

57 questions posted

Ask a Question

Usually answered in minutes!

Top Poulan Garden Experts

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Are you a Poulan Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...