Poulan 14" Chainsaw "adjust air gap spark module" Questions

Ad

Question about Garden

1 Answer

...air gap 010 012?Spark seems a little week.Exhaust is clear.Whats up. The spark plug should be about 0.025" gap. With a fresh plug, the spark should be blue. If fairly weak looking, remove the cover ...

Ad

...I tried adjusting the ignition module to as close to .30 as possible. theres your problem. air gap on the module is 10 thou not 30 thou. set proper and if that is your only problem then unit will ...

Ad

Question about Poulan Garden

1 Answer

air cleaner, and muffler for plugging. Check the fuel lines for decay or other problems. Be sure that you have fresh fuel mix in the tank. Check the quality of the spark at the plug--it should be blue

air cleaner, and muffler, for plugging. Does the saw 4-stroke at speed when running free, but immediately 2-stroke when cutting? If not, adjust the H jet needle CCW somewhat until the previous occurs.

Question about Poulan Garden

1 Answer

air cleaner, and muffler for plugging. Check the condition of the fuel lines for decay or other damage. Check for spark at the plug--it should be blue and snappy (gapped 0.020"). If it looks weak, try

...air filter. Can't figure it out Homelite is known for this issue with there newer chain saws. The problem is with the carb, it needs to be adjusted, basically it is running to rich and needs to be ...

Question about McCulloch Garden

1 Answer

gap is 0.020". Having to keep the choke closed to make it run implies that the main jet in the carburetor is plugged or if adjustable, the setting is too lean. Make sure the air cleaner is not plugged

...air filter and muffler for plugging. Is the fuel fresh and properly mixed with a modern synthetic oil at 50:1 ratio? When it quits, remove the spark plug and test for blue, snappy spark. If it looks ...

...air vent in fuel cap so it's not drawing vacumn.Remove and clean spark plug,check for any cracks in porcelien insulation. I have had this happen where it would start fine when cold but when hot ...

gap is correct. Blow out the cylinder with compressed air to vent all the residual gas/oil within. Ground the new plug against the engine and pull the cord. You should observe a fairly bright spark at

Not finding what you are looking for?
Poulan 14" Chainsaw Logo

143 questions posted

Ask a Question

Usually answered in minutes!

Top Poulan Garden Experts

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Are you a Poulan Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...