Question about Poulan Garden
ignition module, spark plug. Using new gas and oil. Has good spark but won't pop. Chainsaw won't start. Replaced carburetor, fuel lines, fuel filter, ignition module, spark plug. Using new
...replace the spark plug and see if that works. The 240 is a newer husqvarna; so I am skeptical to say it is the ignition module. However, any new product can have a bad part on it. Your saw may have ...
...the ignition module on the powermac 310 and still get no spark. How do I test the ignition module out off the chainsaw? Or how do I know an ingnition module is working properly prior to
ignition module. The switch completely disintegrated on my Mac and in the process ground through the insulation on the wire going to the switch. Replaced both components and have good spark again. The
...ignition switch wire from the module coil. Check the pole gaps of the module by inserting a thin business card into the gaps after turning the flywheel magnets under the module. Loosen the module ...
pack? It could be the ignition module, but if since it is firing I would say it is a bad fuel filter. Try replacing it. Also, try using fresh gas. Mix a 50/50 gas to engine oil mixture and put that in
...ignition module gap to the flywheel magnets with a thin business card for a gauge. Remove the left side case to expose the flywheel and ignition module. Turn the flywheel to bring the magnets under ...
...spark with. An old one that is black inside is likely shorted. If still no spark, replace the ignition module. Use a piece of card stock to set the flywheel magnets to module gap, then tighten ...
ignition module, so i replaced it and now it still wont start. it has good spark and the carb gets plenty of gas. it ran fine untill the spark plug wire got damaged, thats when i replaced the ignition
6 questions posted
Usually answered in minutes!
1,998 Questions
1,006 Questions
710 Questions
725 Questions
285 Questions