Husqvarna Chain Saw 18" 450 Model 966955438 "bar getting enough" Questions

bar to have enough slack to get the chain on correctly. Reinstall the bar and holding nuts (loosely at first) and adjust the chain tensioner screw so that the chain is tight enough that can pull up on

...and lines up with chain guard slot. Try loosening the chain just a little bit. Not enough to have it come off the bar, but enough to reduce the friction between the chain and the bar. Hope this

...getting oil from the resovior to the chain/bar. If you cleaned the obvious area and the chain is not coated with oil, you may have a clog further up (inside) the oil delivery mechanisms. Also, drain ...

...that can be adjusted.The bar does not get enough oil. I see oil coming out of the hole for the bar but it is just a little bit not enough to keep the chain lubricated. I found the oil

...bar is obstructed. Other possibilities are sawdust getting in the reservoir while filling it and blocking off the tube, or it not being adjusted to feed enough oil. There is usually a screw on the ...

...the bar towards the main body of the saw just enough to slip the chain back on then tighten it carefully, just tight enough to keep the chain on but not so tight that the chain doesn't rotate

front of the bar while it is running. Keep steady pressure on the trigger and hold the chain about 4-5 inches away from the piece of material. If you see a vertical line, the bar is getting enough oil

...enough so the bar can be slid back 1/2 an inch.Look at the chain on the bottom of the bar the sharp part of the teeth should be pointed back at the motor.Take the old chain off with gloves.The saw ...

...bar and chain on and it dosent get enough oil on chain just a small amount between teeth, ive cleaned bar and chain, and do not see a oil adjustment screw on bottom? The hole in the bar pad is the ...

...getting to the bar there is saw dust built up on the outlet and if that isn't the case the pump could be week to remove the pump take off the clutch and there is 2 screws behind the clutch have ...