McCulloch 16 Inch Gas Chain Saw MCC1635AK "chainsaw starts hard" Questions

...set pull cord very hard to pull runs well after started The flywheels are keyed on the Husqvarna chainsaws, there is not way to change the timing. I would suspect you may have some carbon build up ...

chainsaw was working great. It started with hard to start, saw the priming bulb was not getting fuel after continuous pumps. Put the chainsaw on its side, opened fuel cap and started priming. Saw that

...chainsaw is hard to start and when it does start and i start to use it it will die my chainsaw is hard to start after i get it started and start to cut the chainsaw will stop First and foremost. The ...

...chainsaw is hard to start and will not re-start once it is warm. Any suggestions besides junk it. Spend $ 40 for a tune up at a local chainsaw seller/mechanic. Most Stihl outlets are very good. It ...

chainsaw starts and runs fine for a few minutes craftsman 18 inch chainsaw starts and runs fine for a few minutes then dies hard to restart close chock it will restart open chock and it will start and

hard pull start this is anew saw very hard to pull strart The Poulin has a very hi compression you need a good harm.

...hard to start,have old 61 that starts better then new one 1) Check plug & gap if that doesn't work try new plug. 2) Try cleaning air filter 3) Clean out main jet 4) Test petrol filter inside tank ...

...chainsaw hard to start changed fuel when it finally starts it runs for a few seconds then stops and it will not start again try running it with out the muffler if ok without the muffler open it and ...

...chainsaw won't start seems to be flooding have replaced carb and primer bulb Try changing the air filter first as a dirty filter will cause an engine to flood and hard to start. Do this before you ...

4 y/o oulan chain saw hard to start and quit running, no spark. My saw has been hard to start and when it does it bogs and stalls as soon as throttle is pressed. it quit while cutting and has not ...