...the motor it might be possible to locate a replacement from a different source at a reasonable cost. In the case of a very expensive tool it could be worth considering a local motor repair or
...the blade quits turning. Pull it back and turns again. You may have some burnt windings in your motor. If so, you'll have to replace the
I have a Rubi ND 200 wet tile saw 3 yrs old pro use. The motor is now very noisy and getting noisier in use, the bearings appear ok any ideas If the brushes wear out or break it can make these types ...
My target wet saw, on top of the motor has a part in it that overheats due to getting wet, there are two wires soldered. one labeled E, going to the motor,it seems to be an overload device possibly? I
replacement bearing/shaft assembly saw discontinued. can't find parts. Machine Shop my mk 470 motor bearing is done how do i replace them
...holds the motor stationary over the tray had snapped and I cannot find ANY replacement parts for this saw on Rigid.com TILE SAW WTS2000L ;THE UNIVERSAL GUIDE CATALOG NUMBER #:6006001.I NEED TO BUY ...
...you have visited that place before ..(not judging you) the reset on those fractional horsepower motors are typicaly not very robust if it has tripped more than 15 times chances are it's done time ...
Question about Saws
...outdoor project before the winter sets in. check where your power cord goes inside the saw to the motor. All that wrapping the cord around to pack it up sometimes works it loose. Other wise id take ...
...The problem could be bad brushes. Otherwise, you are probably burning the windings inside your motor. The slight banding noise could be an issue with the bearings in the motor itself. In which ...
My MK-100 does nothing when I turn on the switch. Check the brushes for the motor. very common problem in electric motors. It should look like a slotted head of a screw on the side by the motor.
3 questions posted
Usually answered in minutes!
53 Questions
40 Questions
32 Questions