...TOF function (if fanfold paper is used), you should first set the tear position (see above). Press the Setup key. The printer changes to setup mode. Press the Adjust (2) key. Press the TOF (3) key. ...
Question about Tally Office Equipment & Supplies
...TOF Low values to be used. Upon completion the printer will exit back to 'Calibration Mode' flashing the PAUSED light if successful or the FAULT light if not successful. Note: Before calibrating, be ...
TOF moves I have set the position of the first line to be printed. On first test it works correctly. On second test it moved down by one line. On third test it moved back up by one line. On fourth ...
...set., If the printer is not setting this or the paper just feeds through when loading paper, go into the test menu, select pcalib and make sure no paper is in the printer. aslo make sure the printer ...
...TOF and ATO set perfectly. Now I need to find how to adjust the width of print. I have the Tractors set as far as possible to the right but the print is still approaching 1/2" further to the right ...
...SET THE PAPPER.TEHN I GIVE THE TOF BUTTON NOT AT ALL REVERCEING THE PAPER. This problem is occure due to Logic Card Problem or Paper feed motor Problem. Bhavin - India this problem is occure due to ...
...print head. If the rollers are dirty, cards can slip and cause ribbons to break. Another is the TOF setting. If the print image is too close to the front edge, the ribbon will break. Check these 2 ...
...set, the unit will give a TOF error. If you hae pressed the feed button and kept pressed for at least 4 labels, and it does not automatically calibrate, check the type of sensor. If you still get ...
Question about Tally Office Equipment & Supplies
...TOF switch is for the setting of top margine so it will move the paper revers up to top margine which is set by you. solution #2 To solve this problem set the emulation to your printer confugration ...
FEED" until the tear is where you want it and press "SHIFT" > "TOF" to back back to the previous page (or top of form). Simply put, pressing "PARK" then "LOAD" should set the tear where you need it
113 questions posted
Usually answered in minutes!
197 Questions
69 Questions
77 Questions
43 Questions
54 Questions