...in tight among the screws and sometimes the normal vibration of the tool will cause a screw to cut into a wire and short the wire. new brushes and holders (if melted) are usually around 20 dollars ...
...brushes and field. Lood for burned or melted wires or case parts. Milwaukee is notorious for running lots of small wires in very tight places. Make sure none of them got pinched when the tool was ...
...brushes, at the front of the tool are 4 screws that need to be removed after removing them you might have to pry the gearcase from the motor housing and then it should just pull out if there is no ...
...melted the insulation on the wires of the motor coils), but it won't find a shorted motor coil. Use an ohm-meter to compare the resistance of each coil. Try a pair of contacts (where the brushes ...
Fault on a Kinzo 115mm Angle Grinder I have a Kinzo 115mm Angle Grinder. When I was using it on a job I got carried away and eventually brown smoke came billowing from the Grinder. It no longer works ...
...brushes in my DeWalt DW402 Type6 angle grinder and now when plugged in and the switch activated it sounds like it has a hammer inside and the motor gets hot quickly. The grinder will never get up to ...
2 questions posted
Usually answered in minutes!
53 Questions
40 Questions
32 Questions
