Homelite RIDGID 3000 PSI 26 GPM CAT Pump Pressure Washer RD80903 "pump getting 10" Questions

Ad

Question about Little Giant Plumbing

1 Answer

10E-CIA-sfs, Impeller needs a push to get started. Any suggestions? Sorry to tell you this but youre going to need to get a new one. Try a place called "harbor freight" think you might like the prices

Ad

Question about Little Giant Plumbing

1 Answer

...pump to turn on, it must be under 7" to 10" of water. The water gets into the switch housing (which has an opening in it) and water pressure pushes on the rubber diaphragm (much the same as you did ...

Ad

Question about AO Smith Plumbing

1 Answer

...pump has a high pitched squeal when it turns of and it is getting worse. The model is E3 It sounds like a bearing going in the motor. Most likely the front and probably not oil-able. If it is, 10 ...

pump turns on and in about 10 seconds it shuts off a little piece on the back gets red hot it has a wire going to the capacitor Guessing the capacitor is probably bad. It sounds like the run capacitor

...However, even if the water pump pressure is only 10 psi, it should reach your faucet. 10 psi pressure is equivalent to 23.1 feet vertical height. So, please check it up and get back to us by

pump doesn't get above 10 does that mean my impeller is clogged? The motor is definitely working but I can't get the pressure up. I have cleaned all the baskets out also. check baskets for cracks, 99%

...for about 10 to 20 seconds. Check the voltage at the pump while its running. If the electric feed line is too long for the guage wire, voltage drop will cause the motor to overheat and switch

Question about Ingersoll Rand Plumbing

1 Answer

It pumps good until it gets up near the 135 psi cut out, then it stalls the motor and trips the reset. This unit has 10 hrs on it, but is 2 yrs old. Tha I would say that the 135 reading is no longer ...

Question about Liberty Pumps Plumbing

1 Answer

...pump since it is a 2" discharge. If it is not underwater it will get hot and trip thermal overload. Why is it running for 5 minutes? That is a lot of water to move assuming your not trying to lift it ...

pump. If you aren't able to figure it out, it would probably be a good idea to get a repair service. Generally a plumber will be able to help out with this, but good luck with getting this fixed! http

Not finding what you are looking for?
Homelite RIDGID 3000 PSI 26 GPM CAT Pump Pressure Washer RD80903 Logo

6 questions posted

Ask a Question

Usually answered in minutes!

Top Homelite Plumbing Experts

john h

Level 3 Expert

29494 Answers

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66931 Answers

Are you a Homelite Plumbing Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...