...2 other compressor's model #C2000 sitting on our bench with the same condition. Thank you Your compressor will not build pressure if there is a leak or the cylinder/packing is worn. Easy tests. Use ...
...2 stage twin v. the motor runs and it is pumping air but it will not build any pressure. The compressor should pump into a final check valve where the pressure switch is located. Check the condition ...
...2 Cylinder, Oil Capacity 2 Quarts, Pump Speed 685 RPM, Bore Size 4 3/4 x 2 1/2 Inches, Stroke 3 Inches, Motor Sheave Diameter 6.75 Inches, Flywheel Diameter 16 1/2 Inches, W 18, Depth 16 1/2 Inches, ...
Question about Craftsman Air Tools & Compressors
...2 stage oil free air compressor. It will not build pressure? I have replaced the check valve, checked the filter and still no luck? Help Problem sounds like valve plate /reed valves or worn cylinder ...
Question about Dewalt Air Tools & Compressors
...2 long bolts each side of the cylinder, remove them and lift the cylinder straight up gently until the piston is out of the cylinder then the rod/piston should slide forward off the crankshaft and ...
Question about Stanley Air Tools & Compressors
...or adjust. Any info will help. Its a model CAP6OP-OF. Thanks Your compressor could have worn cylinder /ring, worn/ leaking/ or broken reed valves or just leaking at a joint (check for leaks ...
Question about Air Tools & Compressors
...cylinder campbell hausfeld air compressor about 1 1/2 years old the connecting rod to one of the pistons broke and it caused damage to the crankshaft. will have to replace crankshaft and connecting ...
Question about Ingersoll Air Tools & Compressors
...2-lubrication. However I think the bearings in in the compressor are needing attention. More because it sounds like there is an oiling problem in the compressor itself. At an absolute ...
Question about Porter Cable Air Tools & Compressors
2. that you don't have any air leaks on the top end of the compressor or on your lines going out of the tank. If these are OK, your problem lies either in a damaged valve plate or cylinder/piston. You
36 questions posted
Usually answered in minutes!
35 Questions
30 Questions
27 Questions