...After about 5 minutes it starts back up. Connections are fine, no apparent problem. fan or relay problem welder is protecting itself from burning up when it cools off will run fine check relay or ...
Question about Welding Tools
...my mig 125 welder . it turns on but will not arc? turns on, fan runs no arc when connectivity is made with metal, fully grounded Secondary winding on transformer burned out? Is there an internal
Question about Welding Tools
mig welder won't arc or weld. fan runs and wire feeds but does not weld. I thought it might be the rectifier but can the diodes be replaced? if so where can I find them? You can buy the diodes online,
...welder . now no welding . checked ground, replaced tip ,tightened thumb screw on cable, fan runs ,wire feeds , no weld. check main contactor or diode bank. Check the relay box it small, square, you ...
Mig I am running 0.30 wire welding a roll cage on a race car the welder keeps overheating {light keeps coming on} wont weld just sputters keeps kicking the breaker {20 amp} sometimes even when you are
Question about Clarke Power Products Welding Tools
...welder fan is running and when i push triger air flows but wire motor does not run Check the heat resistor which is located on the circuit board behind the wire speed dial! Looks like a white oblong ...
fan of the machine works and looks ok but the motor doesen't run. Unplug you welding gun and try to bridge the connector, if the motor turns, then you have a faulty trigger, if not your PC board needs
Fan runs but nothing else Plugged in fan runs but nothing else does check small wire on opposite end of Gun. May not be connected well
Question about Miller Welding Tools
...mig welder fan runs, wire advances no fire or sparks even on ground clamp My first thought would be to pull the boot back off of the gun where it goes into the machine and make sure the cable isn't ...
Question about Miller Welding Tools
...mig welder doesnt stay on all the time should it? The fan does not run continuously. It only runs when it needs to. It depends on the work load of the welder. Short runs do not cause it to heat up ...
3 questions posted
Usually answered in minutes!
1 Questions
2 Questions