Question about ViewSonic Office Equipment & Supplies
...power on and the lamp led not the I've got a ViewSonic projector PJ458D I press the power on and the lamp led not the power led goes amber for about a minute and shut off the power of the projector ( ...
...projector checked, testing with particular attention the high voltage board that will supply power to the lamp. That may be the fault. If you have a replacement lamp in storage replace the lamp
Question about Hitachi Office Equipment & Supplies
...not reset-no manual Pressed reset could not get rid of screen. Power & lamp light flashing Now switch power on , power & lamp lights on ,no screen, Fans appear to work normally how to change the ...
power the lamp up, there is not even a flicker, and it then flashes a red lamp light on the top panel - which suggests a fauly lamp. Now the lamp is good (and so are the 4 spares I have) as I have put
Question about Panasonic Office Equipment & Supplies
...power mode. After lamp replacement projector functioned for a short time, lamp time never reset. Was serviced under warrantee after lamp replacement. I suspect time accumulation on counter prevents ...
Question about Optoma Office Equipment & Supplies
power up sequence, lamp fail comes on (tested lamp in another projector), powers down and enters normal flashing green state. I suspect the lamp supply. any comments? The lamp might be burn out or you
...power light and the lamp light is red. This usually means you need to replace the lamp. 1) To do this, power off the machine and disconnect the power cable. 2) Open the lamp compartment, and remove ...
Question about NEC Office Equipment & Supplies
...Power and Lamp. I run the system with no lamp but all this did was make the status light flash 2 or 3 times and then stoped flashing I then put the good lamp back in but still no change as the Power ...
Question about Sony Office Equipment & Supplies
...power button, fan lamp will not come on. Press power button, fan come on, lamp light blinks for a few seconds and then pgoes out and power light blinks and fan shuts off . Have changed lamps, ...
...lamp light (after power-down) I'm wondering if either the after-market replacement bulb is faulty (it looks ok), or if I've damaged some other component when the bulb blew. Any help much ...
32 questions posted
Usually answered in minutes!
11 Questions
12 Questions
9 Questions
11 Questions