Question about Datamax DMX Office Equipment & Supplies
...stock with an eye-mark, ensure that your print does not interfere with the area at the eye-mark. The printer will try to print the format, but if the eye-mark is in the way, even if the format is ...
Question about Datamax DMX Office Equipment & Supplies
...to push the buttons in the correct order to configure the printer. Also use at least a 6" long label, and print the config file to see if you are set correctly for gap mode if using die cut
Question about Datamax DMX Office Equipment & Supplies
label stock selected to make sure they match. Next check the setting on the printer its self for the same for label stock selected. Most likely you're trying to use a label stock different then it was
label sensor is over the gap on the die cut stock. if not die cut? If reflective, make suree you have the correct sensot set in the printer configuration. You can go to test, and print a conf label to
Question about Primera Technology Office Equipment & Supplies
...label stock and feed button doesn't feed at all either. I've tried turning it off and on, but maybe the label stock is too thin? It is 1.625" wide.. There is an sensor position adjustment, from where ...
Question about Primera Technology Office Equipment & Supplies
...stock). I am getting a very thin white line sometimes at the top of the label, sometimes at the bottom. Sometimes at the left and sometimes at the right. I've tried reloading the stock, adjusting the ...
...label stock) is changed.Before running the Auto-Calibrate operation, check the QUICK SETUP or MEDIA CONTROL menu for the 'Label Length' parameter. It should be set to the length of the label, ...
Question about Datamax DMX Office Equipment & Supplies
...sensor's view of your label stock. Then calibrate the printer. Press and hold "FEED" until the printer cycles 8-10 times. Let go. Printer should say Calibration Complete and you should be good to
Question about Zebra Office Equipment & Supplies
...2. The ribbon is loaded backwards 3. You are trying to do direct thermal printing (no ribbon) but the label stock is not direct thermal stock. Maybe you can provide more details. Hope this
Question about HP Office Equipment & Supplies
...label stock, now it does not pull the stock through correctly which messes up the labels. Is there an adjustment on the feeder feet or any other solution to the problem? Thanks check the paper type ...
43 questions posted
Usually answered in minutes!
20 Questions
0 Questions
1 Questions
3 Questions
1 Questions