Kyocera Mita FS 3800 Laser Printer "check toner error" Questions

Check the appropriate toner cartridge lock lever (Shown below) and make sure that it is in the correct position. CORRECT POSTITION INCORRECT POSITION Check both transfer belt lock levers (Shown below)

...and remedy- Install a specified toner cartridge. Check the SIM 26-6 setup. Replace the EEPROM. Replace the toner cartridge. Replace the MCU PWB. Check connection of the CRUM connector. Execute SIM

...toner and check whether the same error code is displayed for it also, then try using the case/cover of the original toner if u can fix it on this new one, i have tried it and it worked for me(but for ...

...Check Waste Toner'. Open the front cover and put the waste toner back in. Let the printer go through the usual checks and hopefully all should be well. In my experience this can be caused by not ...

...developer unit Causes: Defective toner motor. Check procedures/corrective measures: Replace the developer unit Causes: Defective engine PWB. Check procedures/corrective measures: Replace the engine ...

...The waste toner transfer motor is not operating properly. Does the error still occur? Yes Check to confirm that the waste toner transfer system is operating properly. Replace the waste toner

...The drum unit is installed. We've turned the machine on and off but the error message comes back. How do we fix it?? remove the yellow plastic from the toner thats a protection. check around

...Toner level sensor/K (PS16) Printer control board (PRCB) -- Step Action: 1 Check the connector between each sensor- PRCB PJ21 for proper connection and correct as necessary. - - 2 Replace the toner ...

...toner duct for ID is not operating properly. Check to confirm that the basket assembly is in position (if it is engaged with the gear of the printer). Check to confirm that the holder magnet D ...