Question about Office Equipment & Supplies
What model or industry part number of ir sensor do i search for to fix my Omnitech paper shredder? It's a model:OT-EXC10A After the power button is set to ON It runs continuously on automatic. It runs
how to reset sensor for fellowes P57Cs Which kind of sensors? The auto start sensors? If the shredder non stop working you can try clean it. You must open cover, replace cutting module and clean ...
the basket full light will not go out I've cleaned the sensor several times but each time I turn on the machine it will operate for about 5 seconds before the basket full light comes on again (basket ...
Question about Fellowes Office Equipment & Supplies
runs continuously when in the on position. there is paper jammed in front of the sensor. it was likely caused by feeding too much paper into the shedder at one time and now a chunk of shedded paper ...
...fixes to this issue? thank you, your help is greatly appreciated. Some shredders have optical sensors with a dark sensor LED on one side of the slot, and a clear transmitter LED on the other. ...
...the time When I put the switch in the auto position the shredder stays on all the time. Is there a sensor that needs to be cleaned? This is what worked for me. 1) unplug the shredder 2) put the ...
...have to turn off manually. Either there is a piece of paper that is jammed where the paper in sensor is located, or there is paper fibers covering the paper in sensor, or the paper in sensor is ...
works only in reverse All shredders have a switch or optical sensor to tell when you've put paper in the slot. This isn't working for some reason. Switches can go bad or the actuator breaks off. In ...
...continually after a piece if papper is shredded. How can I correct that? Dlcrrawford, You have a sensors problem replaced both. good luck Kacretail: You have a bad sensor. your sensors are going ...
27 questions posted
Usually answered in minutes!
61 Questions
64 Questions
52 Questions
31 Questions
23 Questions