Question about Delphi Audio Players & Recorders
...wires are buried. Will the power connection & antenna connection from my Roady work on the Onyx? yes. Just plug in the antenna from the XT base into the Onyx base, plug in power and
...On the receiver unit (not the head unit) the IP Bus cable has an attached wire that runs to the power input harness. The other wire from the power input harness is the problem. I can't remember ...
...power connection is not being made by an internal problem or wear caused by constantly plugging and unplugging the power port. I use a Cambridge XM playdock boombox at home. I bet getting a different ...
...power 2. Antenna connected and located in the same place--No Signal. We've tried several channels. 3. Confirmed cable from Aux connections on receiver to Roady2--all correct. We also connected the ...
Question about Sirius Satellite Radio Audio Players & Recorders
connection to the changer doesn't keep it on all the time as it seems to be doing with the SIR. One thing to note, the HU is hard wired to the battery. Both the ignition as well as the main power wire
...power connection around the power pin. You will have to use a needle to try to poke and pull the plastic piece out and off of the power pin, then it will work - a common problem and it has happended ...
Question about Sirius Satellite Radio Audio Players & Recorders
...connection to the unit. If it was installed at a shop, take it back and have them move the power source to the same wires that the radio gets power from. If you are using your cigarette lighter for ...
when my receiver is plugged into my boom box, I get a display reading "check cradle for power" It's not receiving enough power from the boombox so the voltage drops too low for the ...
Question about Sirius Audio Players & Recorders
problems with the power cord. Loses power. You have to open it up, break it down carefully to 4 pieces. There are 4 solder points on the female part of power socket. With the radio on the table, have ...
Question about Delphi Audio Players & Recorders
..."wirelessly" with Car Radio (inherent design of unit). Place Unit in Cradle; connect Cradle to Auto Power Source, and SkyFi3 should power on. Press Menu to Get FM Radio station channels; select a ...
75 questions posted
Usually answered in minutes!
148 Questions
105 Questions
43 Questions
25 Questions