...DC/DC voltage converter circuitry or the main board, caused for moisture as result of the water drops. In order to perform a correct diagnostics and repair of it, it is necessary to open such camera ...
...dc. Under test, if the battery voltage drops slowly, it is bad. A very good battery will actually show a slight increase in voltage under load. Make sure the polarity (+,-) of the batteries installed ...
dc. The voltage across a battery isn't really the thing to look for. It's the amperage available from the battery which counts. An almost flat battery can still read it's correct votage but as soon as
...voltage the battery has. Most batteries are 3,7 or 7,2 volt. when you use a multimeter, the reading in DC should be something like 3,9 or 7,5. On the meter the outage should be a few percent higher ...
...see if the 3.0 volt DC voltage is present on the center pin of the battery connector, if it's there, you can safely assume the data is there as well. I wish you luck! Joe Weibel ...
Question about Olympus Cameras
...When you try to measure the voltage with a multimeter (Set it to DC), it should read at least 3,8 volt. If it is less, you can assume the battery won't work as soon as you put it in the camera. ...
...DC. Then measure between the "S" and "+" and it should also measure about 8 volts. Next, you need to see if a short circuit in the camera is loading down or draining the battery. Put the battery in ...
...drop the camera (at least) if it bites you.. :) so from the safety angle if you don't have at least some electronic training I cant recommend opening the camera.. The only possible suggestion that is ...
...DC converter in the camera which converts the batteries voltage into several regulated supplies for use by the camera. Return the camera the Sony Laredo and let them know what it is doing, some of ...
174 questions posted
Usually answered in minutes!
374 Questions
347 Questions
302 Questions
275 Questions
244 Questions