Optoma EP719 XGA DLP PROJECTOR 2000L 2500:1 CONT DVI-D WITH HDCP Multimedia Projector "bulb goes" Questions

...Bulb fires then goes out Infocus LP130, New bulb and old bulb same. Bulb lights and rear fan spins, front fan does not, I have swapped fans around and both are working OK. Bulb fires up for around 15 ...

goes black. The red bulb light comes on when the screen goes black. I put a new bulb in about four months ago. The bulb has about 200 hrs of use. Reset the lamp hours as follows. Press the Exit button

...bulb counter you need to access the Service Menu: To access the Service Menu: Turn on and warm up press the following sequence: Up Up Left Give it a few goes, it took me 5 minutes to enter with the ...

...but only stays lit for around 20 seconds then goes out and the red bulb light lites up indicating a problem with the bulb. We replaced the bulb and it does the same thing. Try cleaning the

...bulb goes on. I've disconnected everything and reconnected, turn it on and it works for about two minutes and shuts off projector, red bulb light comes on. Is the lamp going bad? Have you tried ...

bulb has gone .. why because it goes out the processor is told this and the machine acts accordingly . Now I have had where the plug that is in the bulb housing is at fault the connectors expand under

...secs then goes back off, you need to reset the Bulb Hour Timer. http://www.infocus.com/Support/LampHours.aspx I just fixed my LP130 this way. I replaced the bulb once, but didnt reset the timer

...happen? I was told that when the bulb goes it doesn't explode it gets dimmer. did you have the fan on? usually it explodes because of excessive heat, make sure the fan works when you replace the ...

Epson PowerLite 50c goes dim even with new bulb the Epson PowerLite 50 is dim even with new bulb check bulb smps

bulb. Well I did just that and now when I turn it on, it displays the computer image fine but then after a minute the picture goes blank (completley black) for five seconds, then it returns to normal.