Mitsubishi HC3800 1080p Home Theater DLP Projector Projector "fan working projector" Questions

you're sure the fan works but no voltage, hope you're good at soldering. you need to remove the main board and solder a jumper from the bad fan's power and ground to the working fan's power and ground

...projector can only be shut down by eliminating the power supply. The unit gets very hot check fan filters. sounds like you have an airflow problem. open up and clean out dust. or fan failure. check ...

Fan not working Just replaced the bulb and now our fan stopped working so the projector turns on and then after a minute it turns off. The fan never turns on. This suggests the bulb is not correctly ...

...the projector work? Make sure not to shut down the projector after use. Wait until the fan stops. The fan is to cool down the bulb during and after use. Once the fan stops, then you can shut it

...cause premature lamp and projector failure. the fan has 3 wires- ground, power and sensor. if the fan spins too slow or not at all, the projector will shut down to prevent damage. so, replace the

its light is showing not working fan, then it blinks fan working, then blue light showing, then blinking, pls help I suggest call for assistance for that product or replace the bulb of your projector

...working but the one in the front doesn't. Smetimes the other fan comes on when set to full bright. As your lamp is not lighting up, the other fan will not come on. If yo have replaced the lamp and it ...

...working. We don't get an image from it. We purchased a bulb thinking it was burnt out. That wasn't the problem. Any suggestions. we were unable to pull the projector menu & it also took about 2 hours ...

...in it. u can use any type of lubricating oil. rotate the fan leafs with finger for some time. after that re-stick the spec sticker. insert the fan in the projector. power ON the projector and watch. ...

...projector on.The fan at the front of the projector also comes when i power the projector. pls help me cos i need to do a presentation with it tomorrow if you haven't already try cleaninig the filters ...