Frigidaire FDF50S Dehumidifier "normal setting" Questions

humidity level keeps blinking on display , is that normal on the Albert dehumidifier What does the user manual say about this? That is normal when the room humidity level (as detected by the hygrostat

...the humidity set point is reached, the compressor shuts off but the fan continues to run. Is this normal? Chucke - Depending on which mode you're operating the unit in (Continual Mode), yes

...normal humidity with the fan setting on high. While the unit itself cycles on and off the fan runs all the time. Is this normal? I f I put the fan seeting on low the fan doesn't turn off and on ...

...80% listen 4 one fan and compressor to stop , this is all normal reset desired setting on humidistat if unit fails any one of these simple tests it has an internal fault inside it and requires ...

Kenmore 54701 - In "On" mode. Runs briefly then shuts off Is this normal? depends what is it set for does it seem to be taking moisure out maybe needs to be set for higher setting

How do I set the humidity level? as most all of these unit have a humidistat some where on board its case this must be located and set to 70% rH this is the normal rH for your home

...question! May I have your model number please? The serial tag, which lists your model number, is normally located behind your dehumidifier near the bucket. Also, what is the size of the room where ...

...best settings on the control panel? and do I open flap or leave it flat? 70% rh is considered a "Normal" moisture level in inside a home try to maintain as close to that as ...

...an see if it comes on in a few minutes , if it does listen for two motors to run (compressor and fan) this is normal , if not then it might have a problem then reset humidity setting to normal

normal. air should be cooler. Be careful. i do not know. set at highest setting and let it run. while running, reduce setting to the lowest over a few minutes. at a lower setting you should be able to