...stuck when i jump out the switch nothing happens i think it has to do with my ventor motor cause it doesnt start at all Hello,Try unplugging one lead wire to the switch.The inducer should start
...tube and the switch is clicking. Anything else to check? Thanks! Jump out the switch as it first starts then take the jumper off as it ignites. If it starts, its the switch. If not, its the
...START AGAIN UNLESS THE THERMOSTAT IS TURNED OFF AND THEN TURNED BACK ON. Hello, looks like it is going off on it's high limit switch, a limit switch is there to protect the furnace from overheating. ...
Question about Carrier Heating & Cooling
...start up. fuse on board good? do i need to replace motor? Sounds like it to me. You might be able to switch the motor speeds by taking the red wire off the heat spot on the board and taking the one ...
Question about LG Heating & Cooling
sir my lg 1.5 ton split ac power drops very low as soon as compressor starts and ac does not work so i have to switch it off immediately AS SOON AS I SWITCH AC ON FAN STARTS NORMALLY BUT AS SOON AS ...
...start. The fuse switch was off and when switched on there seemed to be no power. Old fasioned switch board with no automatic cut off fuse b ut air conditioner has its own fuse. Look at the fuse board ...
Question about Heating & Cooling
...switch? air con wont start with remote is there a reset,or what can i do to start both of them its 36 dec here? Its odd that BOTH systems failed at the same time unless they are powered with the same ...
...other time it will not start. I have to open up the bottom panel and press the door safety switch a few times and then it will start. Any suggestions! i would first start by replacing the safety ...
Compressor starts and switches off I have a Carrier 1.5 Ton ac. Model - Aspira. The compressor starts and draws 45 amps current and immediately switches off Locked compressor, try a hard start kit to ...
Question about Honeywell Heating & Cooling
...start and closes proving switch normally two are a dual switch positive connects to fan discharge and negative connects to heat exchanger (fan suction )this is to insure air movement threw heat ...
60 questions posted
Usually answered in minutes!
20 Questions
21 Questions
14 Questions