Question about GE Dishwashers
...middle spray arm is attached to the top rack. The end of this spray arm tube where it goes into the back wall is loose. There is an after market rubber washer from GE that goes there to prevent ...
Question about Frigidaire Dishwashers
put everything back except the ball. It has worked well ever since. I had the same problem.I did some testing and realized that the middle arm wasn't moving, but it seemed like water was coming out. I
Question about Kenmore Dishwashers
...unscrew and remove the middle plastic screw, and nearly stripped the plastic screw thread in the process. The middle screw is attached and is supposed to stay put. Everything else lifts off around
...middle is cracked. There should be a round assembly on top that telescopes out this usually un screws then inside there is usually a screw that needs to be removed....put it back the way you took it ...
...put slider rack arm back on the rollers. Another way? The back endcap on the slider has snaplocks that has to be squeezed then pull off. This should allow you to pull the slider out and then guild it ...
...put the rubber band on one end of the rotating piece just for good measure, but I'm not sure it was ncessary to stop the noise. SOLVED! I tried the rubber band thing, but it didn't make a difference, ...
Question about Maytag Dishwashers
...middle is a disc that is somewhat flat and only sticks up about an 1/8 of an inch from the arm, this is what you need to unscrew to remove the arm. It almost looks like part of the arm (especially if ...
...middle spray arm of a mile 865 is falling off....i have reinserted it a few times....i may need an entire new assembly includiing the plastic arm plus the three fittings. Do you have them You can get ...
Middle Spray arm has fallen off! Don't ask me how that happened, but I can't snap it back on. Is there a trick. Does it attached under the center of the top rack? Also a plastic O -ring piece has ...
...put it back together, the top arm would spin only when i had the 2 middle arms disconnected. It seemed there was an increase in pressure. i ran a diagnostics test and there were no errors. i figured ...
538 questions posted
Usually answered in minutes!
214 Questions
206 Questions
161 Questions
175 Questions
145 Questions