...shaped) screw drivers and some patience in reassembly. Be sure to note how things are assembled before removing them. You do not need to unplug the unit to do this as you will be inside the unit and ...
Question about Kenmore Dishwashers
shaped piece up though the new spinner until it snapped into the pin (it took a fair amount of force to make it snap in). Thanks for the advice! I came here today looking for the solution to this same
...plastic caps that once removed will allow you to slide the rack off of the metal slides. Next, the long L shaped spray bar that goes up the back and across the top needs to be un-clipped and removed, ...
...shaped plastic float switch. If it doesn't lift, remove the plastic top from the stem, scrub the stem clean, and then replace the dome. If it moves up and down freely, go on to Step 3. 3) Note which ...
...shaped float that couldn't move due to the glop. I simply held the whole plastic thing under the sink faucet to rinse it out. I had to take off the tub pan in order to pull off the drain hose that's ...
...plastic cap, and then check for any soil buildup. Clean if necessary. Is there a loop in the drain hose less than 20" above the floor? Make sure the drain hose is looped so that it touches the ...
...plastic fan blade-type of device that spins around. This is the wash impeller, which forces the water through the spray arm. Beneath the wash impeller is the drain impeller, which is similar in size ...
...plastic bracket and it seems to be rather fragile in that it would be rather easy for it to break its seal. What do you think. In this Kitchenaid dishwasher model KUDS01FLSS2, the whole motor and ...
...shaped) screw drivers and some patience in reassembly. Be sure to note how things are assembled before removing them. You do not need to unplug the unit to do this as you will be inside the unit and ...
125 questions posted
Usually answered in minutes!
485 Questions
214 Questions
206 Questions
161 Questions
175 Questions