My jvc stereo is stuck on protected and it won't change the radio station off protected Radios that are in "protected" mode often indicate a short in a speaker wire or a really bad speaker. Disconnect
...on the radio When the radio is turned on protect starts flashing. Wires all seem to be ok wires are ok but speakers may not be which can put it into protect.other then that your head unit has an ...
...radio to go into protect mode, that's your culprit. If neither of these are the issue and the radio decides to stay in "protect" mode, your receiver may have seen better days and may need a ...
...radio back in still flashing protect Chances are pretty good either the output ic or the volume control ic inside of the radio are bad. Both require the ability to use a soldering iron to
...protect and it wont come off the screen or play radio or cds what do i do? This radio is equipped with an anti-theft device, if the battery power is disconnected from the radio for more than a few ...
Question about Kenwood Car Audio & Video
a time and reset the radio but the protect still flashes check the speakers for shorts or grounds. if all checks out fine try disconnecting power to the deck for a few seconds and then reconnecting it
Question about Kenwood Car Audio & Video
Car Stereo in Protected Mode will Not Play Radio or CD I own a Kenwood Car Stereo. The KDC-MP238. While playing a CD I hit a large pot hole and the Radio went into ''Proteced'' Mode. It will no longer
...protect, then radio is bad...If it doesnt, power off and hook up speakers one by one and power it back on till it shows protect again....When it does, the last speaker wire you hooked up has either a ...
Question about Kenwood Car Audio & Video
..."reset". push a pin in the hole to reset the radio. Most of the time that will take it out of protect mode and radio will work. if it is still in protect mode, then do what tech says, test the
...radio was blinking protect Hi. Protect mode is a special condition that kicks in when an internal fault has been detected. In protect mode all the unit function are disabled to prevent the stereo ...
109 questions posted
Usually answered in minutes!
202 Questions
203 Questions
165 Questions
142 Questions
149 Questions