Kenmore 24902 Top Load Washer "water floor 80 series" Questions

...just go through the holes at the bottom of the basket. Then it goes all over the floor. When the washer spins, the water also goes all over the floor. sounds to me like you have a hole in your ...

floor. Upon reconnecting the washer the cold water seems to slow fill sporatically. If I turn the cold water valve off at the wall, and turn in back on, the cold fills just fine. I cleaned the screens

...water, it overflowed the top and flooded my floor. It did not go in to the spin cycle. Kitchen Aid top Load Washer overfils going into the rinse cycle and just keeps filling. It does not alwawys do ...

...water runs on floor. Is there a sensor or relay for fill level> Hello. Yes there is a fill level pressure switch. It is pressure activated by the pressure of water rising in a tube as the water rises ...

...to see if the belt is still attached and also take the drain hose down to floor level to see if the water gravity feeds out, if it does not pour out then your pump would likely be clogged from

...water was running for 3 hours, before I realized it. The tub fills fine when it is in the wash cycle. I have a Kenmore series 80 washing machine. I recently had floor put in, and the washer was moved ...

...you can do but replace the water valve they dont come apart for cleaning,or could take apart but looking for trouble because wont then seal and will over flow on to floor.you can do it .God bless ...

...floor)) Blow any water out of the air tube, it should be empty when the washer is empty, water remaining in the tube messes up the pressure sensing (usually makes water level lower) ensure wires are ...

Small amount of water goes into the tub but leaks from wherever preventing more water to fill the tub. Sounds like a drain hose or pressure switch hose is loose. Is the water leaking visible on floor