Kenmore Elite 21086 "set timer hot tub" Questions

...timer set to it to open up when it's time, that wire harness that hooks into it is just causing the problem. Hopefully though all it needs is a good cleaning. Let me know if you have any other ...

...set. Has worked well over last few years. In recent weeks, noticed that towels and jeans are more wet than usual, and has become gradually worse to the point that most types of loads that are descent ...

...set the timer on a 1996 hot tub? It has an old timer with things (prongs) that you have to push/pull?! These types of timers were used and are still used for many different devices. The dial ...

...set the water level ( small - medium - large ). The water level control is responsible to shut off the power to the fill valve and direct that power to the timer so the washing machine can start up. ...

...hot. Timer allows only beginning rinse cycle, quits then goes to spin cycle. Have replaced the timer unit already. Before I attempt to replace anything else, thought I'd ask for some help. Check to ...

...set to Hot/Cold, it works perfectly. When I run the same cycle on Cold/Cold, it doesn't. It will fill and drain fine, spins at full speed, and the water shuts off when it is full. The problem is that ...

...timer, use a VOM set to the RX1 scale. Disconnect the power leads to the timer and clip one probe of the VOM to each lead. The VOM should read zero if the timer is working. Since the timer is a ...

...set for a few (3) hours it will start working. I was wondering if the pump is plugged and the water can't drain very fast would this cause the pump to over heat and we have to wait for the reset to ...

Set the timer dial on regular and pull the knob to turn the timer push-pull switch on * Set the temperature switch to the cold/cold setting * Open the controls panel to gain access to the water mixing

Set the timer dial on regular and pull the knob to turn the timer push-pull switch on * Set the temperature switch to the cold/cold setting * Open the controls panel to gain access to the water mixing