Kenmore 24032\24036 Top Load Washer "wash cycle timer jumps" Questions

...wash cycle and the rinse cycle befor why does my washing machine skip rinse and spin cycles then a code of oL comes on the timer also jumps from 12 min to 3 min during this process sounds like you ...

...cycle Most likely problem is the timer failure. Generally if it is something else like a sensor, it will not do anything but just sit there while the time runs (if it is a mechanical timer) If it is ...

Timer jumps When selecting a cotton wash which normally takes 1hr26 mins clock jumps after a few miutes dowm to 45 mins. This may happen on other washe cycles but guidance on what to do to stop this ...

Washer will not do cycle Normally, timer may be bad. Check or jump out timer. If not that , which cycle.

...cycle,you can temporarily jump(bypass) it with a wire be careful(has 120 volts) across it,also check around lower end by motor for burnt or corroded connections,it could be timer contacts,but not ...

...wash cycle, the timer jumps to the next cycle and the machine continues washing without stopping at the end of the cycle. It seems that the timer is not sending the proper message to the motor ? ...

...cycle (number 5 and 9) on my beko washing machine also if you change programmes the programmer jumps round Prog jumps as it will carry out 1st command selected unless reset.the sticking could be a ...

wash cycles to the rinse and spin cycles If the unit is skipping cycles you will need to replace the timer.Here is the part you need to order.The part comes with a 365 day, any part, any reason return

...then jumps from 1 hour 00 to zero completing the drying cycle in about 15 minutes rather than 1hr 50mins. I have not noticed the same problem on the wash cycle! Any ideas? check heat sensors or ...

...cycle timer may have failed. Most likely a control board issue This similar behavior is exhibited when the lid opened/closed. Check the lid switch assembly for malfunction and that cabling secured at ...