Question about Asko Washing Machines
...it work again? may have defective timer (burned points at the delicate cycle mode) can but may be difficult take timer apart and sand paper clean the point contacts on timer DONT IT BEFORE BUT NOT ...
...timer you will see what sort of looks like a bunch of flattened out pins. these are connectors and mine were dirty preventing a good connection. i used a metal nail file to clean them ( you can use a ...
timer does not advance, there is a humming sound and no water is dispensed. most new washers have a cold water only rinse be sure cold water hose is connected to cold side of valve and turned full on
... open the the housing of the control & clean the contacts with a burnising tool or emory fine grain sanding paper. This step will be like a watch repairman. Your brushes are worn down or your cam has ...
Question about Bosch Washing Machines
...timer sees that there is still water in the drum it adds more time to allow for the water to be removed. front bottom access panel will get you into the fluff/filter to clean it out. Make sure to get ...
...sand) Now, unscrew the big thing next to the hose, which is a filter. Chances are there is something there blocking the flow of water to the pump. If it is clear and still no pump out, you will have ...
Question about Washing Machines
sand, started a few months later. To try and get it going, swapped out a used motor and timer, a capacitor, lid switch and belt. Disassembled the pump and cleaned it out. I'm out of ideas, any help is
...sand or debris. If this is clear you will have to do a voltage check at the valve to see if it's getting 120V when calling for water. If you are getting voltage there and no water, replace the valve ...
Question about Washing Machines
...sand/sediment dropping into the hot water heater tank first before it continues on to the washer. CAREFULLY pull out the screen, BEING EVER SO CAREFUL TO NOT TEAR THE WIRE SCREEN OR CRACK THE PLASTIC ...
Question about Kenmore Washing Machines
timer. a little more details would help. My solution was first of all disconnected the power by unpluging power cord from the wall outlet. Seperate the switch assembly from the machine. Then carefully
3,909 questions posted
Usually answered in minutes!
3,839 Questions
2,098 Questions
1,642 Questions
1,023 Questions
908 Questions