Kenmore 24032\24036 Top Load Washer "pressure schematic" Questions

...pressure switch as the schematic shows. See attached schematic Pic. If you open up the rear console three # 15 Torx screws on the rear condole the schematic should be inside for your machine console. ...

...pressure switch then i would have to assume the problem is in the timer. If you can read the schematic (usually located behind the control panel you could check to see if you timer is sending 120v ...

...pressure switch tube came off and floor flooded. The clear tube is hanging straight down. What does it need to be attached to? If you go to sears.com and take the link to parts direct, you should be ...

what does the water level pressure switch look like, and where is it located behind the panel?? self help says it could be a stuck contact for an F2 code, as one of the possible fixes. a few taps on ...

pressure switch but there is a part that I have been unable to determine it's location. Question edited for clarity. The full parts schematic is here. https://www.searspartsdirect.com/model/2ijiytav2u

...pressure switch that regulates how much water is supposed to be in the tub thinks that theres too much water. So its constantly trying to drain. If you can give me a model # I can be sure, and also ...

schematic for machine PDF format , just need an e-mail adr., a hard copy should be in the Machine Console. Here is a link to the Service Manual for reference and Sears Parts Direct for reference if it

...packing slip with all the information on the error codes and electrical schematic. F17- covers the following problems - supply hose kinked/jammed, clean filter, water pressure too low..hope this ...

...http://www.partselect.com/Schematics/GE/00123300i01.gifLook at part number 10. This is called the pressure switch and controls the amount of water that goes into the machine. What I would do is put ...

...has a schematic of most of the Spacemaker macnine. Hope it helps ! ...