Kenmore 24032\24036 Top Load Washer "noise gear slipping" Questions

...noise is mechanical in nature so if it is, it could be anything from loose belts, gears, bad bearing in the motor....slipping agitator mounted to it's support shaft.....etc....it's difficult to say ...

when the washer goes into the spin cycle, the transmission sound like a gear slipping. a very loud noise, it's like two pieces of steel hitting each other. try avoing speen cycle

...gear case bad if it spining makeing a loud noise and makeing a bad ratching noise in spin cycle may be a plastic piece that involves the gears, it breaks causing the same problem you descibe that i ...

...noise in spin cycle and smoke coming out of drum Make sure the drum is actually spinning during that cycle (I bet it isnt). If not, the clutch is slipping- I had this happen years ago. It's in the ...

noise Hi, without knowing exactly what the sound sounds like its hard to tell.If the drum trys to spin this could be the sound of a slipping clutch. If it doesnt it could be the transmission doesnt go

...noise while slipping.The advice on YouTube suggested it would be a difficult repair involving gear box etc, and technically challenging.Note: The US washing machines are easy to dismantle compared to ...

...noise as though a gear or belt is slipping, it shows in the tub that it's slipping by jerking in the direction it is trying to move. It is so common that the washing machine can make terrible ...

...noise when "goes into high gear" on spin cycle but still spins slow and belt is not slipping Hi, A loud popping noise could be a fault in the electrical capacitor (aka condenser) near where the power ...

...noise could be coming from the gears inside the timer slipping. if it is a kenmore, usually, it has these plastic cover on each side of the control panel. pry it slowly and lift it to exposed a screw ...

kleenmaid While agitating there's a cruching noise as if the gears are slipping. Is it worth fixing? No not worth fixing if the gear box is going out .